Installing brushes
Note: If the brushes have been replaced, sand their contact surface (#500, #600) before installation.
1. Install the armature with the brush holder into the stator.
2. Connect the brushes to the brush holder and install the springs.
3. Install the insulator and back cover.
Disassembling and assembling the starter.
1 - traction relay,
2 - anchor,
3 - overrunning clutch,
4 - drive lever,
5 - drive side cover,
6 - front bearing,
7 - back cover,
8 - rear bearing,
9 - insulator,
10 - spring,
11 - brush holder,
12 - brush,
13 - stator.