Checking wheel alignment
1. Place the vehicle on the stand.
2. Unscrew the wheel hub mounting nut.
3. Install the special device.
4. Measure the wheel alignment.
If the camber does not correspond to the established norm, check the suspension elements for damage and bending. If necessary, replace the faulty element.
5. Remove the special device.
6. Tighten the new wheel hub mounting nut.
Checking the convergence
1. Measure the toe-in (toe-in checking procedures are described in the section "Checking and adjusting the front wheel alignment angles").
Table. Wheel alignment angles.
2. If the toe-in is not within the nominal value, check the suspension and replace the faulty parts.
(The article was copied from the website: HondaBook.ru)