Checking the air flow direction flap actuator (air conditioning with automatic control) (Honda Fit 1)

1. Disconnect the damper actuator connector.

2. Connect the positive battery terminal to terminal "1" of the actuator connector and the negative battery terminal to terminal "2" and check that the actuator operates in the "VENT" direction. Reverse the polarity of the battery connection and check that the actuator operates in the "DEF" direction.

3. With the battery connected to terminals "1" and "2", make sure there is conductivity between terminals "7", "3", "4", "5" and "6".

(Publication reprinted from the website: «HondaBook.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Varvara Vereshchagina

◀ Previous

Fit 1: Heater and air conditioner

Next ▶

Removal and installation the air flow direction flap actuator (air conditioning…
Checking the air flow mixing flap drive (air conditioning with automatic…
Removal and installation the air flow mixing flap drive (air conditioning with…
Checking the Sunlight Sensor (Automatic Air Conditioner)
Removal and installation the sun sensor (air conditioning with automatic…

Checking the power transistor (air conditioner with automatic control)
Self-diagnosis (additions for right-hand drive models from 06.2004)