Note: Installation is carried out in the reverse order of removal.
1. Remove the glove box.
2. Disconnect the connector (A), loosen the mounting screws and remove the air flow direction flap actuator (B).
Removal and installation the air flow direction flap actuator (air conditioning with automatic control) (Honda Fit 1)
1. Remove the glove box.
2. Disconnect the connector (A), loosen the mounting screws and remove the air flow direction flap actuator (B).
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Checking the air flow mixing flap drive (air conditioning with automatic…
Removal and installation the air flow mixing flap drive (air conditioning with…
Checking the Sunlight Sensor (Automatic Air Conditioner)
Removal and installation the sun sensor (air conditioning with automatic…
Checking the cabin air temperature sensor and the ambient air temperature…
Removal and installation the air flow mixing flap drive (air conditioning with…
Checking the Sunlight Sensor (Automatic Air Conditioner)
Removal and installation the sun sensor (air conditioning with automatic…
Checking the cabin air temperature sensor and the ambient air temperature…
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)