1. Remove the trunk lid and decorative panel from the passenger compartment.
2. Remove the wiper arm from the outside of the trunk lid. Remove the union nuts, washers and arm nut from the wiper arm.
3. Disconnect the wires from the wiper motor.
4. Remove the mounting bolts and the motor itself.
5. Assembly is carried out in the reverse order. Make sure motor connections are secure. Tighten the mounting bolts with a torque of 10 Nm. When installing the wiper arm, leave a gap of 25 mm between the glass and the blade. If the wiper is too far out of position - higher or lower - they will slap too hard when working on wet glass.