Electric valves A and B of pressure in the automatic transmission clutch — replacement (Honda Avancier 1)

1. Unscrew 6 bolts (6 x 1.0 mm) and remove the A and B pressure solenoid valves in the automatic transmission clutch as an assembly.

2. Clean the installation area of the solenoid valves and oil channels. Make sure there is no contamination.

3. Install new O-rings and gasket. Install oil supply pipes and A and B pressure solenoid valves in the automatic transmission clutch.

Caution: Avoid exposure to foreign particles.

Install filters (3 pcs.) on the oil supply pipes. Install the filters as shown in the figure (the side of the pipe with the filter is towards the automatic transmission housing).

4. Make sure there is no rust, oil, dirt, etc. inside the connector. Install the connector securely.

(The original is located on the website www.hondabook.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

Avancier 1: Automatic gearbox

Next ▶

Automatic transmission clutch pressure solenoid valves A and B — checking
Electric valves B and C of gear shifting — replacement
Shift Solenoid Valves B and C — Check
Torque Converter Lockup Solenoid Valve and Shift Solenoid Valve Assembly —…
Torque Converter Lockup Solenoid Valve and Shift Solenoid Valve Assy — Check

Intermediate and secondary shaft speed sensors — replacement
Pressure switches in 2nd and 3rd gear clutches — replacement
Switch D3 and Switch Low hold — replacement
Automatic transmission selector lever switch — replacement
Automatic transmission selector lever switch — check