Torque Converter Lockup Solenoid Valve and Shift Solenoid Valve Assembly — Replacement (Honda Avancier 1)

1. Unscrew 3 bolts (6 x 1.0 mm) and remove the locking solenoid valve and gear shift solenoid valve A.

2. Clean the installation area of the solenoid valves and oil channels. Make sure there is no contamination.

3. Install the new seal with filters, then install the locking solenoid valve and the switching solenoid valve A.

4. Make sure there is no rust, oil, dirt, etc. inside the connector. Install the connector securely.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

Avancier 1: Automatic gearbox

Next ▶

Torque Converter Lockup Solenoid Valve and Shift Solenoid Valve Assy — Check
Electrical fault diagnostics — diagnostic description
Component arrangement
PGM-FI Control Unit Pin Locations
Electrical diagram

Shift Solenoid Valves B and C — Check
Electric valves B and C of gear shifting — replacement
Automatic transmission clutch pressure solenoid valves A and B — checking
Electric valves A and B of pressure in the automatic transmission clutch —…
Intermediate and secondary shaft speed sensors — replacement