2. Disconnect the 3-pin connector from the lock cylinder switch.
3. Check the continuity between the contacts in each switch position and make sure that continuity exists only in the case shown in the figure.
Checking the driver's door lock cylinder switch (Honda Avancier 1)
1. Remove the driver's door trim (see chapter Body).
2. Disconnect the 3-pin connector from the lock cylinder switch.
3. Check the continuity between the contacts in each switch position and make sure that continuity exists only in the case shown in the figure.
2. Disconnect the 3-pin connector from the lock cylinder switch.
3. Check the continuity between the contacts in each switch position and make sure that continuity exists only in the case shown in the figure.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits