2. Disconnect the 3-pin connector from the lock actuator assembly.
3. Check the continuity between the various contacts in each switch position and make sure that there is continuity only between the contacts connected by the lines in the table.
Checking the switch of the locking lever of the driver's door with electric drives (Honda Avancier 1)
1. Remove the driver's door trim (see chapter Body).
2. Disconnect the 3-pin connector from the lock actuator assembly.
3. Check the continuity between the various contacts in each switch position and make sure that there is continuity only between the contacts connected by the lines in the table.
2. Disconnect the 3-pin connector from the lock actuator assembly.
3. Check the continuity between the various contacts in each switch position and make sure that there is continuity only between the contacts connected by the lines in the table.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits