2. Disconnect the upper and lower radiator hoses and ATF cooler hoses.
3. Disconnect the fan motor connector.
4. Remove the upper radiator bracket, then take out the radiator.
5. Remove the fan shroud assembly and other components from the radiator.
6. Install the radiator in the reverse order of removal. Make sure the upper and lower mounts are securely in place.
7. Fill the radiator with engine coolant and bleed it (Figure).
1. RADIATOR CAP
2. 6x1.0 mm, 9.8 Nm (10 kgf/m)
3. UPPER BRACKET AND CUSHION
4. RADIATOR
5. COOLANT RESERVOIR
6. 6x1.0 mm, 7 Nm (0.7 kgf/m)
7. LOWER CUSHION
8. O-RING, Replace.
9. DRAIN PLUG
10. ATF COOLER HOSES. When installing see chapter 10.
11. LOWER RADIATOR HOSE
12. FAN MOTOR CONNECTOR
13. RADIATOR FAN SHROUD ASSEMBLY
14. 6x1.0 mm, 7 Nm (0.7 kgf/m)
(Original material on the website «HONDABOOK.ru»)