Locations of body glazing components (Honda HR-V 1)

The numbers after the component names indicate the quantity of components used.
1. WINDSHIELD MOLDING
2. UPPER MOLDING SEAL, 2
3. UPPER RUBBER GASKET
4. SIDE MOLDING SEAL, 2
5. FASTENING, 2 (self-adhesive, from the body side)
6. FASTENING, 2 (self-adhesive, on the glass side)
7. LOWER RUBBER GASKET
8. WINDSHIELD. Replacement (see below)
9. REAR GLASS MOLDING. Replacement (see below)
10. UPPER MOUNT, 2 (self-adhesive, from the body side)
11. UPPER MOUNT, 2 (self-adhesive, glass side)
12. UPPER RUBBER GASKET
13. LOWER MOUNT, 2 (self-adhesive, on the rear door side)
14. LOWER MOUNT, 2 (self-adhesive, on the rear window side)
15. LOWER RUBBER GASKET
16. REAR CENTER EMBLEM
17. REAR GLASS. Replacement (see below)
18. GLASS HOLDER (2)

1. REAR SMALL SIDE WINDOW TRIM
2. UPPER RUBBER GASKET
3. SMALL SIDE WINDOW. Replacement (see below)
4. TOP CLIP (self-adhesive)
5. FRONT TRIM FOR SMALL SIDE WINDOW (self-adhesive)
6. LOWER CLAMP (self-adhesive)
7. LOWER RUBBER GASKET
8. BACK CLIP (self-adhesive)
9. CLAMPING THE TRIM