Tightening torque:
- support bolts "B" - 59 Nm
- support bolts "C" - 49 Nm
2. Install the rear gearbox on the jack.
3. Install new snap rings (A) onto the drive shafts. While lifting the rear axle, install the drive shafts.
4. Connect the ventilation tube.
5. Install washers (A) and tighten bolts (B).
Tightening torque:
- bolts "A" and "C" - 39 Nm
- "D" bolts - 59 Nm
5. Align the marks on the flanges of the propeller shaft No.2 (A) and the rear gearbox (B) and tighten the bolts (C).
- Tightening torque - 32 Nm
6. Install the engine exhaust pipe.
- Tightening torque - 22 Nm
7. Fill the rear gearbox with oil.