Wheel replacement (Honda Avancier 1)

I Preparation

1. Stop the vehicle on a level, hard surface, remove the on-board tool and spare tire.

2. Apply the parking brake, support the wheel on the diagonally opposite side of the punctured wheel with stones on both sides, for example.



3. Place the spare tire under the vehicle near the punctured tire (face up).

II Raising the car with a jack

1. Install the jack (see above).

2. Using a wheel wrench, loosen the wheel nuts (approx. 1 turn).



3. Rotate the jack to raise the vehicle so that the tire is slightly off the ground.

III Wheel replacement

1. Loosen the wheel nuts, remove the cap and remove the wheel.

Note: When placing the wheel on the ground, make sure the face of the wheel is facing up. Placing the wheel face down may scratch the rim.

2. Wipe the contact surfaces of the spare wheel hub and disc.



3. Install the spare tire.



4. Tighten the nuts and tighten them slightly so that they touch the seating surfaces of the holes and the wheel does not wobble.



5. Lower and remove the jack. Tighten the nuts in 2-3 passes in the sequence shown in the figure.

• Wheel nut tightening torque: 10.0-12.0 kg·m

IV Fixing a punctured tire

1. Wheel with cast disk.

Remove the center cap from the punctured wheel.

2. Place the punctured tire in place of the spare, turn the spacer over and secure the wheel.

V Installation of road wheel

1. Wipe the contact surfaces of the disc.



2. When installing the cap on a road wheel, align the recess on the cap with the air valve.



3. Tighten the nuts and tighten them slightly so that they touch the seating surfaces of the holes and the wheel does not wobble.



4. Lower and remove the jack. Tighten the nuts in 2-3 passes in the sequence shown in the figure.

• Wheel nut tightening torque: 10.0-12.0 kg·m

(Full text available on the portal HONDABOOK.ru)