Removal the jack
1. Grasp the hook, lift the lid and hook it onto the loop of the rear shelf.
2. Remove the jack.
Jack mounting locations
Raising a car with a jack
1. Stop the car on a level section of road with a hard surface.
2. Apply the parking brake, support the wheel on the diagonally opposite side of the punctured wheel with stones on both sides, for example.
3. Place the jack on the ground and turn it by hand until the jack groove fits into the mounting location on the car body.
4. Rotate the jack using the jack handle and lever to raise the vehicle until the tire is slightly off the ground.
Attention:
When the car is raised with a jack, do not do any work under the car under any circumstances. This is very dangerous, as the jack may fall off.
To ensure safety when using the jack, follow these guidelines:
- Do not start the engine on a jacked vehicle. Do not use the jack on a soft surface.
- Install the jack only in designated areas.
- Disembark passengers and unload luggage.
- Use the jack only when changing a wheel or putting on chains.
Note: Use only the jack from your vehicle, do not use jacks from other vehicles as they may not have the correct load capacity or may have different mounting locations.