Ignition distributor repair (Honda HR-V 1)

1. back cover; 2. distributor runner; 3. lid seal. check for damage; 4. Distributor cap. Check for cracks, wear, damage and dirt. Clean or replace.; 5. magnetic shield; 6. ignition coil; 7. distributor housing. check for cracks and damage; 8. O-ring. Replace.; 9. Ignition Control Module (ICM)

(Publication reprinted from the website: «www.hondabook.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

HR-V 1: Engine electrical equipment

Next ▶

Replacing the ignition distributor
Checking and adjusting the ignition timing angle
Ignition system — basic information
Checking the starter operation
Assembling the starter

Testing the ignition coil
Checking and testing high voltage wires
Checking spark plugs
Charging system — basic information
Generator replacement