1. rear pillar trim; 2. hook; 3. rear side shelf; 4. Front seat belt upper anchor bolt, 7/16-20 UNF, 32 Nm (3.3 kgf/m); 5. B-pillar trim; 6. door finishing; 7. hooks; 8. Front pillar trim; 9. left wheel arch panel; 10. right wheel arch panel; 11. sections B; 12. sections A; 13. side trim; 14. pin; 15. rear side decorative panel; 16. groove
1. rear central shelf; 2. sections A; 3. sections B; 4. spare wheel cover; 5. luggage compartment lighting. remove the rear pillar trim (see above); 6. screw et; 7. rear shelf support; 8. side trim (see above); 9. door finishing; 10. Rear side decorative panel. Remove the rear seat cushion, rear seat back and rear side shelf.; 11. Lower rear seat belt anchor bolt, 7/16-20 UNF, 32 Nm (3.3 kgf/m); 12. to the body; 13. luggage frame; 14. rear bucket floor element; 15. rear decorative panel; 16. hook; 17. hooks
1. Flap pocket; 2. rear door trim; 3. pin
1. 4 (with sunroof), 5 (without sunroof); 2. ceiling upholstery; 3. without a sunroof; 4. handrails; 5. ET screw; 6. technological roof plug; 7. sun visor; 8. holder; 9. roof finishing; 10. bushing; 11. lock washer; 12. cap
1. roof side shock absorber; 2. side roof gasket
Installation is carried out in the reverse order of removal, taking into account the following:
- Replace damaged clamps.
- Before installing the anchor bolts, make sure the seat belts are not twisted.
Note:
- When pressing components with a flat-head screwdriver, wrap it with protective tape to avoid damage.
- Do not bend or scratch the headliner.
- Avoid damaging the instrument panel or other interior trim.
1. Remove:
- Interior light
- Rear view mirror (without roof spoiler) (see above).
- Front pillar trim (both sides) (see above).
- Center pillar trim (both sides) (see above).
- Rear pillar trim (both sides) (see above).
- Castle cover (with sunroof) (see above).
2. Remove the sun visor and holder on both sides.
3. Remove the caps, unscrew the screw and remove the handrails.
4. Remove the roof trim (with sunroof).
5. Remove the clip, then remove the roof trim through the rear door opening.
6. Remove the roof side gasket and roof side shock absorber.
7. Installation is carried out in the reverse order of removal.