2. Loosen the bolt and remove the EGR valve.
3. Installation is carried out in the reverse order of removal.
Note: Do not reinstall the "C" gasket.
(The original can be found on the resource: HONDABOOK.ru)
Recirculation system valve (Honda Fit 1)
1. Disconnect the EGR valve connector.
2. Loosen the bolt and remove the EGR valve.
3. Installation is carried out in the reverse order of removal.
(The original can be found on the resource: HONDABOOK.ru)
2. Loosen the bolt and remove the EGR valve.
3. Installation is carried out in the reverse order of removal.
(The original can be found on the resource: HONDABOOK.ru)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)