Note:
- When removing the roof trim, refer to the assembly drawing "Roof Trim".
- Installation is carried out in the reverse order of removal.
1. Remove the front pillar trims (see section "Interior trim").
2. Remove the upper center pillar trims (see section "Interior trim").
3. Remove the rear pillar trims (see section "Interior trim").
4. Remove the interior mirror (see section "Side and interior rear view mirror").
5. Remove the local lighting lamp.
6. Remove the interior light bulb.
7. Loosen the screws (C) and remove the sun visors (A). Remove the sun visor holders (B) in the sequence shown in the figure.
- Tightening torque - 5 Nm
8. Remove the covers (B), unscrew the screws (C) and remove the auxiliary handles (A).
- Tightening torque - 5 Nm
9. Remove the roof trim as shown in the "Roof Trim" illustration.
a) Disconnect the clips (A) and bend back the rear edge of the roof trim.
b) Remove the seals of the front and rear side doors (see section "Interior trim").
c) (Models with sunroof) Disconnect the pins (B) and clips, remove the plug and slide the roof trim back.
d) (Models without sunroof) Disconnect the holders (C) and remove the wiring harness.
10. Remove the roof trim (A) through the open rear door.
Roof finishing.
1 - roof finishing,
2 - clamp,
3 - plug,
4 - wiring harness,
5 - rear pillar trim,
6 - rear side door seal,
7 - front door seal,
8 - upper trim of the central pillar.