2. Disconnect the clips (A), then remove the front (B) and rear (C) trims.
3. Installation is carried out in the reverse order of removal.
Front overlay.
Back cover.
Removal and installation roof trim strips (Honda Fit 1)
1. Remove the roof trim.
2. Disconnect the clips (A), then remove the front (B) and rear (C) trims.
3. Installation is carried out in the reverse order of removal.
Front overlay.
Back cover.
2. Disconnect the clips (A), then remove the front (B) and rear (C) trims.
3. Installation is carried out in the reverse order of removal.
Front overlay.
Back cover.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)