2. Loosen the lock nut and remove the cable housing from the rack.
3. Unscrew the two nuts and disconnect the cable from the accelerator pedal.
4. Install in the reverse order of removal.
5. After installing the cable, start the engine and warm it up until the radiator fan operates twice, and then warm it up for more than 2 minutes at 3000 rpm without load.
6. Secure the cable sheath so that there is no free movement of the tow rope.
7. Loosen the adjusting nut so that it is 3 mm from the stand.
8. Press the adjusting nut against the rack.
9. Tighten the lock nut.
Attention.
- Tighten the lock nut securely.
- After installing the cable, check the idle speed (see above).