Registration plate lighting lamp (Honda Avancier 1)

Replacing lamps

Caution: Do not scratch the bumper during work.

1. Slide the license plate light and remove it from the rear bumper.

2. Disconnect the 2-pin connector.

If only the lamp is being replaced, remove the diffuser and replace it.

(Refer to the original source on the website: «HONDABOOK.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Emil Safonov

◀ Previous

Avancier 1: Headlights and lighting

Next ▶

Turn signal repeaters — replacement
Headlights — replacement, fault diagnostics
Checking the Light/Turn Signal/Fog Light Switch
Lighting system wiring diagram
Location of lighting system components

Rear combination lights
Reversing lights — wiring diagram
Fog lights
Brake lights
Turn signal/hazard warning lights

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet