Knock sensor (Honda Fit 1)

Note: The sensor is checked using a scanner.

Removal and installation

1. Remove the intake manifold.

2. Disconnect the sensor connector.

3. Remove the knock sensor.

4. Install the sensor in the reverse order of removal.

(The article was taken from the website «HONDABOOK»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This information has been verified: Varvara Vereshchagina

◀ Previous

Fit 1: Control system

Next ▶

Intake Air Temperature Sensor
Coolant temperature sensor
Absolute Intake Air Pressure (MAP) Sensor
Electronic control system — device

VTEC System Valve (L15A)
Oxygen sensor
Electronic control unit
Checking the crankcase ventilation system
Fuel vapor recovery system

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet