Note: The sensor is checked using a scanner.
Removal and installation
1. Disconnect the absolute pressure sensor connector.
2. Unscrew the bolt and remove the sensor.
3. Install the sensor in the reverse order of removal.
Absolute Intake Air Pressure (MAP) Sensor (Honda Fit 1)
1. Disconnect the absolute pressure sensor connector.
2. Unscrew the bolt and remove the sensor.
3. Install the sensor in the reverse order of removal.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)