Side and interior rear view mirror.
1 - side mirror housing,
2 - side mirror,
3 - lock bolt,
4 - lock washer,
5 - support,
6 - holder,
7 - interior mirror,
8 - cover.
Note: Installation is carried out in the reverse order of removal.
1. Remove the front door trim panel and access hole cover.
2. Raise the glass fully.
3. Disconnect the connector (A) and remove the clamp (B) of the side mirror drive wiring harness.
4. Remove the plug (A), unscrew the three nuts (B), disconnect the clamp (C) and remove the side mirror housing (D).
- Tightening torque - 9.8 Nm
5. Disconnect the clips (B) and clamps (C) and carefully remove the side mirror (A) from the drive (D) as shown in the figure.
The original is located on the website HondaBook