Attention.
- Be careful not to damage the body or the components to be removed.
- When storing the removed seat belts, keep them away from direct sunlight, oil and grease. Also, do not drop or subject them to shock.
Remove the following components, and then remove the components shown in the figure in numerical order.
- Rear seat cushion.
- The back of the rear seat.
When removing and installing the seat belt hole cover, be careful not to damage the belt clips (see above).
Install in the reverse order of removal. Check the tensioner and make sure it is good (see below). If the anchor bolts are loosened, do not mix up the order of the washers during installation (see below). Before installing the belt hole cover and before tightening the anchor bolts, check that the belts are not twisted.