Contents: Removable components ⇊ Removal the glass ⇊ Places for installing fasteners and…⇊ Areas for installing…⇊ Primer/glue application areas on…⇊
Separate replacement of the molding and clamps is not possible and they are replaced together with the glass assembly.
If the glass is being reused, cut away the adhesive without damaging the molding.
If the clamps break, the glass can be reused as it can be secured with butyl tape during installation until the adhesive hardens.
For the procedure for removing and installing glass, see the section above "Windshield removal and installation procedure".
Removable components
Before removing the glass, remove the following components (see below):
- Finishing of the additional stand.
- Finishing of the rear pillar.
- Upper side trim of the luggage compartment.
Removal the glass
Places for installing fasteners and butyl tape
Install the fastener along the reference lines on the molding.
Areas for installing fasteners/applying primer on the body
Primer/glue application areas on glass
(Based on materials from the website: www.HondaBook.ru)