Contents: Check on the car ⇊ Examination ⇊
Check on the car
1. Checking the main power window control switch.
a) Remove the main power window control switch.
b) Disconnect the "20P" connector from the switch.
c) Perform the check as shown in the table "Checking the power window main switch (with the connector disconnected)".
d) Connect the "20P" connector to the switch.
d) Perform the check as shown in the table "Checking the power window main switch (with the connector connected)".
If the result is not as described, replace the main switch.
Examination
1. Checking the main power window control switch.
a) Remove the main power window control switch.
b) Check the continuity between the terminals in each switch position as shown in the tables "Front passenger door switch", "Rear right door switch", "Rear left door switch".
2. Checking the electric drive, driver's door window lift.
a) Remove the inner door trim.
b) Disconnect the "6P" connector (A) from the electric drive.
c) Apply battery voltage to terminals "1" and "2" as shown in the table and make sure that the motor starts to rotate slowly.
 |
 |
d) Connect the "6P" connector to the electric drive.
d) Measure the voltage between the terminals as shown in the table.
* It is advisable to use an oscilloscope for this check.
3. Checking the power window control switches for the front passenger door and the rear side doors.
a) Remove the switch (A).
b) Check the continuity between the terminals in each switch position as shown in the table.
 |
 |
4. Checking the electric window lifters of the front passenger door and rear side doors.
a) Remove the inner door trim.
b) Disconnect the "2P" connector (A).
c) Apply battery voltage to terminals "1" and "2" as shown in the table, and make sure that the motor starts to rotate slowly.
Note: When the system reaches the extreme position, quickly disconnect the battery.
 |
 |
Table: Checking the main power window control switch (with the connector disconnected).
Table: Checking the main window control switch (with the connector connected).
[The original can be found on the resource «HondaBook.ru»]