2. Loosen the bolts (A), then remove the bracket (B).
- Tightening torque - 22 Nm
Removal and installation the rear seat bracket (Honda Fit 1)
1. Remove the side trim of the luggage compartment (see section "Interior trim").
2. Loosen the bolts (A), then remove the bracket (B).
2. Loosen the bolts (A), then remove the bracket (B).
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Varvara Vereshchagina
Removal and installation the rear seat cushion retainer
Removal and installation the rear seat guide
Removal and installation rear seats
Removal and installation front seats
Checking the seat belt
Removal and installation the rear seat guide
Removal and installation rear seats
Removal and installation front seats
Checking the seat belt
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling and lubrication system
- Injection and power system
- Control system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heater and air conditioner
- Safety system
- Electrical equipment
- Equipment and devices
- Wiring diagrams (since 06.2001)
- Wiring diagrams (since 06.2004)