- Standard resistance: 2.2-3.0Ω
2. Make sure that there is no conductivity between the slip rings and the rotor shaft.
Insulation resistance measured with a megohmmeter
- Standard resistance: 1MΩ
[Full text available on the portal: hondabook.ru]
Checking the generator rotor (Honda Avancier 1)
1. Measure the resistance between the slip rings.
2. Make sure that there is no conductivity between the slip rings and the rotor shaft.
Insulation resistance measured with a megohmmeter
[Full text available on the portal: hondabook.ru]
2. Make sure that there is no conductivity between the slip rings and the rotor shaft.
Insulation resistance measured with a megohmmeter
[Full text available on the portal: hondabook.ru]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Checking the generator stator
Checking the generator brushes
Checking the generator rectifier
Disassembly and assembly of the generator
Generator replacement
Checking the generator brushes
Checking the generator rectifier
Disassembly and assembly of the generator
Generator replacement
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits