To remove the rotor, loosen the lock nut using open-end wrenches (10mm and 22mm) or an impact wrench (22mm).
The original text of the article is located on the website: HONDABOOK.ru
Disassembly and assembly of the generator (Honda Avancier 1)
Separate the pulley, front cover and rotor only if replacing the front bearing.
To remove the rotor, loosen the lock nut using open-end wrenches (10mm and 22mm) or an impact wrench (22mm).
The original text of the article is located on the website: HONDABOOK.ru
To remove the rotor, loosen the lock nut using open-end wrenches (10mm and 22mm) or an impact wrench (22mm).
The original text of the article is located on the website: HONDABOOK.ru
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits