2. Remove the gear cover and remove the electromagnetic switch from it.
3. Check the conductivity between all contacts of the electromagnetic switch and make sure that there is conductivity between the contacts according to the table.
 |
 |
Checking the electromagnetic switch (Honda Avancier 1)
1. Remove the starter.
2. Remove the gear cover and remove the electromagnetic switch from it.
3. Check the conductivity between all contacts of the electromagnetic switch and make sure that there is conductivity between the contacts according to the table.
2. Remove the gear cover and remove the electromagnetic switch from it.
3. Check the conductivity between all contacts of the electromagnetic switch and make sure that there is conductivity between the contacts according to the table.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits