2. Disconnect the 2-pin connector from the socket.
3. Install in the reverse order of removal.
During installation, align the notch on the panel with the protrusion on the socket.
Electrical outlet — replacement (Honda Avancier 1)
1. Remove the right side trim (see chapter Body).
2. Disconnect the 2-pin connector from the socket.
3. Install in the reverse order of removal.
During installation, align the notch on the panel with the protrusion on the socket.
2. Disconnect the 2-pin connector from the socket.
3. Install in the reverse order of removal.
During installation, align the notch on the panel with the protrusion on the socket.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits