2. Installation is carried out in the reverse order of removal, taking into account the following.
After installation, check the operation of the electric motor using the temperature controller.
Mixing flap motor — removal and installation (Honda Avancier 1)
1. Disconnect the connector, remove the rod, unscrew the screws and remove the mixing flap electric motor.
2. Installation is carried out in the reverse order of removal, taking into account the following.
After installation, check the operation of the electric motor using the temperature controller.
2. Installation is carried out in the reverse order of removal, taking into account the following.
After installation, check the operation of the electric motor using the temperature controller.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This information has been verified: Emil Safonov
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Controls and instruments
- User manual
- Power unit
- Engine maintenance
- Engine repair
- Cooling system
- Engine management
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive shafts and differential
- Chassis and running gear
- Steering
- Car suspension
- Brake system
- Body and interior
- Doors, locks and windows
- Interior (internal elements)
- Exterior (external elements)
- Air conditioner
- Electrical equipment
- Power devices
- Equipment and devices
- Headlights and lighting
- Electrical circuits