Attention:
- When replacing main bearings, check the markings of the crankshaft main journal diameters, the diameters of the holes in the cylinder block, and select the required bearings according to the table.
- If the marking is not visible, clean the marking area with flushing oil. Do not use a wire brush.
- After installing the bearings, check the oil clearance.
- Nominal diameter of the cylinder block bore: 59 mm
Bearing markings
- Nominal bearing thickness: 2.0 mm
Bearings are available with color markings (blue, black, brown, green, yellow and pink) with a thickness step of 0.004 mm.
